Automotive diagnostic tools

  This is an Article showing just how simple it is to flash in DTS Monaco , over DoIP (Diagnostic over Internet Protocol). These newer units can ONLY be flashed over DoIP. Trying to flash them via CAN, will very likely brick your control unit, so that should not be attempted, under any circumstances! A DoIP hardware is required to flash these newer units. Such a hardware can be an SDConnect C4 DoIP , ECOM or VCX SE . DoIP brings signifficant advantage versus CAN, by that it is much faster (eg. flashing times take a few minutes, instead of several hours, telematics disks are not needed anymore, etc etc). Once you own the equipment, it will need to be correctly set up. There are online guides available, that show how to set up these devices. Following is the DTS Monaco guide on how to flash using a DoIP hardware! First, we’ll need to select the relevant SMR-D file, of the control unit, which we’ll be interacting with. Once interfacing with the control unit, before flash...

  Customers feedback recently from European areas have told OBD2 tools e-shop that they have detected the MB SD C4 Plus professional diagnostic tool has connection problem with Mercedes-Benz. What’s the problem gonna be like? And what solution our engineer would provide? Let’s check together. MB SD C4 Plus SD Connect Compact 4 Star Diagnosis Support Doip for Mercedes Benz Cars and Trucks Without Software The Connection Problem is shown like below: Feasible Solution Provided for Customers: First step: In the system file, find Hyper-V manger in windows administrative tools ,then click it. Second step:Click the  Virtual Switch Manger Third step:click the Ether Fourth step: Choose your computer network card in here Fifth step: Right click on the network,Open network&internet settings After entering this interface, select Ethernet, Then select the place marked by the arrow Right click vEtherent  Then select the place marked by the arrow Double click...

  After Benz DTS Monaco Software installation,you need configure DTS Monaco for interface (here take MB SD C4 DoIP as example).So here Obd2tool.com show you guide on how to setup connection between DTS Monaco and MB SD C4 DoIP . Preparations: Benz DTS Monaco 8.16 8.08 Software Free Download How to Install Mercedes Benz DTS Monaco 8.16 Software Procedures: After DTS Monaco installation,open network and sharing center Click “Change adapter setting” Right lick “Local Area Connection” and select “Properties” Select “Internet Protocol Version 4 (TCP/IPv4)”—>”Properties” Select “Use the following IP address”,and set address as below: IP address:172.29.127.35 Subnet mask:255.255.255.0 Then click “Advanced…” Click “Add” Set address as below: IP address:169.254.0.35 Subnet mask:255.255.0.0 Then click “Add” Click “OK” Click “OK” And close Now right click “Wireless Network”,then select “Properties” Select “Internet Protocol Version 4 (TCP/IPv4)”—>”Prop...